Dipstick Tube length

[Maxwell]

Hi Thomas

The dip-stick is 570mm long.
The rubber sleeve from the engine block is - as
near as I can measure - 390mm long

The High Oil mark is Circa 30mm from the end....

Hope this helps.

Maxwell [;)]

[tr7sprint1]

i measured a dipstick assy i have off the engine, the tube is 16 inches or 406.4mm long.




<b>"GETTING SPEED OUT OF A LOW POWERED CAR IS OFTEN MORE REWARDING, THAN WITH TIRE-SMOKING BRUTES" </b>

[Hasbeen]

Thomas, the official Leyland manual states the capacity of the sump
is 4 litres, [7 pints]. The capacity of the sump, & the old style
canister oil filter is 4.5 litres.

I suggest you drain the oil, tip in 4 litres, then adjust the length
of your replacement tube, so the dip stick reads full. Then there is
no guess work as to if you even have the right dip stick.

Hasbeen

[PeterTR7V8]

My wife thinks her dipstick is 5'10".

Wot a liberty!


Never say die. At least not while you're still breathing.

[Hasbeen]

Perceptive, that wife of yours, isn't she Peter?

Hasbeen

[FI Spyder]

Can't seem to get a consensus. My TCT dipstick tube is 15 5/8" or 397mm long. Seems Hasbeens advice is most appropriate here.

Peter, has your wife been talking to my wife?[:D]



TR7 Spider - 1978 Spifire - 1976 Spitfire - 1988 Tercel 4X4 - Kali on Integra - 1991 Integra