Page 1 of 1
TR7 DHC window adjustment
Posted: 03 Jul 2018 10:27
by Traindriver69
Hi all
When I wind the windows up on my 81 DHC they go up too far is there some way of adjusting them so they stop in the right place.
Many thanks
Re: TR7 DHC window adjustment
Posted: 03 Jul 2018 17:32
by dursleyman
There should be a little bracket on the inside of the door that stops it going up too far, part no YKC3620 & YKC3621, called a stop bracket. You can adjust it to set maximum height.
Re: TR7 DHC window adjustment
Posted: 03 Jul 2018 22:13
by Traindriver69
Many thanks for the reply will have a try tomorrow
Re: TR7 DHC window adjustment
Posted: 04 Jul 2018 10:15
by Traindriver69
Hi all
Adjustment worked brilliant many thanks one other question the top quarter light rubber on Rimmer bros diagram it says there is a self tapping screw holding it in but on mine there's nothing its just pushed in and there is no hole in the quarter light for a screw but there is a hole in the rubber.
Many thanks
Re: TR7 DHC window adjustment
Posted: 04 Jul 2018 21:40
by busheytrader
i asked for a couple of the self tapping screws from one of the specialist parts suppliers.
I was told not to bother and just glue the rubber into place. Evostik Impact I guess.