Delco Coil Connector
Posted: 18 Jul 2015 19:01
For my 1980 fuel injection 7: Looks like I need to replace the black plastic, 2-conductor connector that clips into the heat sink end of the Delco coil unit (on the end of the wire from the distributor). The molded black plastic began cracking and crumbling years ago and up to now I'd been able to patch it up with glue and tape. But it's now too far gone to revive. There are just 2 spade type connectors that were molded inside but the housing provided a snap clip to hold the connector solidly in the heat sink opening as well as insulation. So I'd like suggestions for a long term connector fix. (But please not a suggestion to scrap/replace the stock Delco system as all the components are entirely healthy except for this one connector.)