Page 1 of 1

Water in door seal.

Posted: 15 May 2014 20:03
by dursleyman
When I was scraping off old carpet glue I took off the door seal and loads of water came out of it. Should the seal have drain holes? I seem to recall seals on other cars having a couple of holes in them.

Russ

1980 TR7 Sprint DHC, 1981 TR7 Sprint DHC
Dursley
UK

http://tr7russ.blogspot.co.uk/

Image Image[img]http://i1040.photobucket.com/albums/b410/dursleyman/TR7%20web%20picture/IMG_0479-Optimized.jpg[img]

Posted: 15 May 2014 20:23
by busheytrader
The original factory seals (DHC) were filled at either end to prevent them filling up with rainwater.

I've seen aftermarket ones which don't have this, and as the open ends point upwards, they're open to the rain. The hardtop's don't have this problem.

Adam

Image Image

TR7 V8 DHC Jaguar Solent Blue. 9.35cr Range Rover V8, Holley 390cfm, JWR Dual Port, 214 Cam, Lumention, Tubular Manifolds, S/S Single Pipe Exh, 3.08 Rear, 200lb Spax & PolyBushes all round, Anti- Dive, Strut-Top Roller Bearings, Capri Vented Discs & Calipers, Braided Hoses, 4 Speed Rear Cylinders, Uprated Master Cylinder & Servo, AT 14" 5 Spokes or Maestro Turbo 15" Alloys, Cruise Lights, S/S Heater Pipes, Replacement Fuel Tank. No Door Stickers. Mine since July 1986, V8 from 1991 courtesy of S&S V8 conversion and big brake kits.

Posted: 15 May 2014 22:32
by dursleyman
Thanks for that, I reckon its going back on with the ends sealed then.
I might also make a couple of holes in the bottom corners to allow air in and out as well.

Russ

1980 TR7 Sprint DHC, 1981 TR7 Sprint DHC
Dursley
UK

http://tr7russ.blogspot.co.uk/

Image Image[img]http://i1040.photobucket.com/albums/b410/dursleyman/TR7%20web%20picture/IMG_0479-Optimized.jpg[img]

Posted: 13 Sep 2014 13:32
by dursleyman
Update on the door seals.

I put a couple of small V shaped cuts in each seal at their lowest points so any water that gets in can find a way out. I will seal the ends as well when I can find some suitable stuff to use.


Russ

1980 TR7 Sprint DHC, 1981 TR7 Sprint DHC
Dursley
UK

http://tr7russ.blogspot.co.uk/

Image ImageImage

Posted: 13 Sep 2014 13:40
by FI Spyder
I would drill the holes with a small drill bit like the originals. With the ends sealed you need somewhere for the air to go when you compress the seal when the door is closed.
.



- - -TR7 Spider - - - 1978 Spitfire- - - - 1976 Spitfire - - 1988 Tercel 4X4 - Kali on Integra - 1991 Integra - Yellow TCT
Image