tr7triumph.com

I am in the process of sorting out a broken down ball joint and worn shift bushings. What do people recommend for the wrench torque settings for the following:

1. Ball joint castle nut
2. Control arm (link) nut at hinge point bolt
3. Front sway bar end nut at control arm
4. Upper & lower shift bushing bolts

Cheers


80 TR7 DHC with ZS Carbs
Brooklands Green

I'd recommend the work shop manual settings.
You can down load a pdf from jclay's site

<center>
<font color="blue"><i>1980 TR7 DHC (my first car, now restored and back on the road)
1981 TR7 FHC Sprint (better known as 't Kreng)</font id="blue">
<b>[url="http://www.tr7beans.blogspot.com/"]<u><b><font size="2"><font color="red">My Weblog</font id="red"></font id="size2"></b></u>[/url]</b></i></center>

Beans, thanks for the recommendation of jclays website. There is a wealth of good information there.

80 TR7 DHC with ZS Carbs
Brooklands Green