Page 1 of 1
exhaust manifold
Posted: 07 Apr 2011 20:33
by rocky_679
just a querry in the workshop manuals it says gaskets 4 the exhaust manifold are not needed yet rimmers an eveery one sells gaskets for the manifold is ir best to use or not use as im changing from cast iron to stainless steel ???
stephen j dark
Posted: 07 Apr 2011 20:38
by staningrimsby
I went for a stainless manifold during the conversion Rocky and as a matter of course its better to spend the £10 and get the gasket, two metal surfaces mating together will not seal properly.
1980 2.0 16v DHC - Polly.
Posted: 07 Apr 2011 20:44
by john 215
Hi,
The gaskets were originaly for F.I TR7's the carb engines ran nothing, but if you fitting a stainless manifold then i would rec them everytime.
Cheers John
LIVE LIFE A QUARTER OF A MILE AT A TIME!
1979 3.5 FHC(STATUS PENDING!!)
1982 2.0 DHC NOW A 4.6,ON THE ROAD NOW KICKING AR5E !!!!
Posted: 08 Apr 2011 02:02
by FI Spyder
In fact it's common practice (recommended) to use the
FI gaskets on all exhausts regardless.
TR7 Spider - 1978 Spitfire - 1976 Spitfire - 1988 Tercel 4X4 - Kali on Integra - 1991 Integra - Yellow TCT
Posted: 08 Apr 2011 13:07
by bahbzilla
I wondered the same thing when I rebuilt my motor. Everyone I talked to said that TR7's (non-FI) and Stags came from the factory with no gasket. Everyone also said that they did add one if they pulled the manifold and found none...
Bob
1980 TR7 DHC
Posted: 09 Apr 2011 00:01
by Hasbeen
I took Triumph at their word, & have never used s manifold gasket. On each of the 4 I have fitted I used a smear of the red high heat silicone goo, with complete success. I do use a home made gasket on extractor exhaust systems when I have them fitted, as I have found they often distort when hot.
When it comes to the manifold flange gasket, on the stock manifold, which does have a shim gasket, it's an entirely different story. I have always had to replace the studs, & make a gasket out of klingerit to get a satisfactory, long lasting seal.
Hasbeen
Posted: 10 Apr 2011 16:36
by rocky_679
well fitted the gaskets to the manifold now im modifying the exhaust having a straight thru exhaust no centre box just big bore tail pipe i did it on the last 7 as it was rotten an garage said i didnt need 1 so they did last 1 took away the centre box an it ran fine sounded louder tho somthing to wake up the neighbours [:D]
stephen j dark