Anonymous

Easy steer not centering properly

The all purpose forum for any TR7/8 related topics.
Post Reply
Cab2john
Wedgling
Posts: 1
Joined: 03 Jul 2017 12:50
Location: West Midlands

Easy steer not centering properly

Postby Cab2john » 17 Aug 2020 17:24

Hi all, I have fitted an "Easysteer" system to my 80 dhc 2.0L.
It works well apart from not self centering properly, is it an alignment issue ( the bulkhead bearing does squeak sometimes) or is it a lack of caster angle. I fitted an additional brace to the motor to stiffen the assy, so might have caused an issue with alignment. Any ideas?

kstrutt1
Wedge Pilot
Posts: 299
Joined: 15 Jan 2010 14:34
Location:
Contact:

Re: Easy steer not centering properly

Postby kstrutt1 » 17 Aug 2020 18:41

Did it steer and centre before you fitted the easy steer?

If so it can't be caster related.

Even a small amount of friction in the column will also affect its centreing. So you should address this. Try silicone lube on the bulkhead bush. There should be no side load on the shaft, if there is adjust the mountings and use washers as packing to make sure there is no tension in each one.

I'm not sure what type of assist unit you have but some do have a centre position as well if so this needs to be aligned with the vehicle straight ahead.

busheytrader
TRemendous
Posts: 2972
Joined: 14 Oct 2007 17:49
Location: United Kingdom
Contact:

Re: Easy steer not centering properly

Postby busheytrader » 17 Aug 2020 22:06

Hi, I assume the nylon steering column bush in the bulkhead has been replaced with a poly item.

The nylon item in my DHC disintegrated a few years ago and I replaced it with a poly bush. As per kstrutt, it promoted steering stiction especially as it warmed up under use. I used a thick sticky clear silicon grease / gel ( available in small sachet) and it freed up immediately. It only cost a few pounds and I've not had to reapply it since.

Post Reply

Who is online

Users browsing this forum: busheytrader, saabfast, stevie_a and 60 guests